View TLP716_236115.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

TLP716
Preliminary
TOSHIBA Photocoupler GaAlAs IRED & Photo- IC
TLP716
Digital Isolation for A/D,D/A Conversion. High Speed Line Receiver. Microprocessor System Interfaces. Plasma display panel.
Unit : mm
4.58
1.27
3.65
The TOSHIBA TLP716 consists of a GaAlAs light emitting diode and a high speed photodetector.This unit is 6-lead SDIP. TLP716 is 50% smaller than 8PIN DIP and has suited the safety standard reinforced insulation class. So mounting area in safety standard required equipment can be reduced.
6.8
7.62*}0.25
1.25 9.7*}0.3
l l l l l l l l l l
Inverter Logic (totempole output) Package Type : SDIP6 Guaranteed Performance Over Temperature : -40~100C Power Supply Voltage : 4.5~5.5V Input Thresholds Current : IFHL=6.5mA(max.) Propagation delay Time (tpHL/ tpLH) : 75ns(max.) Switching speed : 20MBd(typ.) (NRZ) Common mode transient immunity : 10kV/us Isolation Voltage : 5000Vrms Construction Mechanical Rating
7.62 mm pich standard type Creepage Distance Clearance Insulation Thickness 7.0 mm (min) 7.0 mm (min) 0.4 mm (min) 10.16 mm pich TLPXXXF type 8.0 mm (min) 8.0 mm (min) 0.4 mm (min)
0.4
TOSHIBA Weight: ---g
Truth Table
Input H L LED ON OFF Tr1 OFF ON Tr2 ON OFF Output L H
Schematic
IF
1*{
ICC
6 Tr1
VCC
VF
IO
VO
Tr2 5
Pin Configuration (top view)
1 2 3
GND SHIELD VCC
3*|
6 5 4
1:Anode 3:Cathode 4:GND 5:VO 6:VCC
SHIELD
4
GND
0.1uF bypass capacitor must be connected between pin 6 and 4
1
2003-10-21
TLP716
Maximum Ratings (Ta=25C*j
CHARACTERISTIC Forward Current LED Peak Transient Forward Current Reverse Voltage DETECTOR Output Current Output Voltage Supply Voltage Output power dissipation (Note1) SYMBOL IF IFPT VR IO VO VCC PO Topr Tstg Tsol BVs 5 10 6 6 40 -40~100 -55~125 260 5000 RATING 20 UNIT mA A V mA V V mW C C C Vrms
Operating Temperature Range Storage Temperature Range Lead Solder Temperature(10s) Isolation Voltage (AC,1min.,R.H.=60%,Ta=25C) (Note2)
Note1 : Pulse width PW=10us,500pps. Note2 : Device Considered a two terminal device : pins 1,2 and 3 shorted together and
pins 4,5 and 6 shorted together.
Recommended Operating Conditions
CHARACTERISTIC Input Current , ON Input Voltage , OFF Supply Voltage Operating Temperature SYMBOL IF(ON) VF(OFF) VCC Topr MIN. 8 0 4.5 -40 TYP. 12 MAX. 18 0.8 5.5 100 UNIT mA V V C
--
5
--
The correlation between input current and switching speed and drive circuit (reference information).
Input Current (IF) 12mA 8mA 8mA 1 (Page 4) 1 (Page 4) 2 (Page 4,With Speed up capacitor) 18 - 20 MBd 16 - 18 MBd 20 - 22 MBd TEST CIRCUIT Typical Switching Speed
2
2003-10-21
TLP716
Electrical Characteristics (Unless otherwise specified, Ta=-40 to 100C,VCC=4.5~5.5V)
CHARACTERISTIC Input Forward Voltage Temperature Coefficient of Forward Voltage Input Reverse Current Input Capacitance Logic Low Output Voltage Logic High Output Voltage Logic Low Supply Current Logic High Supply Current Input Current Logic Low Output Input Voltage Logic High Output SYMBOL VF ? VF/?Ta IR CT VOL VOH ICCL ICCH IFHL CONDITION IF=10mA ,Ta=25C IF=10mA VR=5V,Ta=25C V=0,f=1MHz,Ta=25C IOL=1.6mA, IF=12mA,VCC=5V IOH=-0.02mA , VF=1.05V,VCC=5V IF=12mA VF=0V IO=1.6mA,VO<0.4V (Note4) MIN. -- -- -- -- -- 4.0 -- -- -- -- -- -- -- -- TYP. 1.65 -2.0 -- MAX. 1.8 -- 10 -- 0.4 -- 5.0 5.0 6.5 UNIT V mV/C A pF V V mA mA mA
VFLH
IO=-0.02mA,VO>4.0V
0.8
--
--
V
*All typical values are at Ta=25C,VCC=5V,IF=(ON)=5mA unless otherwise specified Note4 : The Photodetector needs VCC of 4.5V or more for the stability operation. In the VCC domain not more than this, since ICCH may increase in part, please use it after checking operation at the time of power supply current, power supply ON, and OFF.
Isolation Characteristics (Ta = 25C)
Characteristic Capacitance input to output Isolation resistance Symbol CS RS Test Condition V = 0,f = 1MHz R.H. = 60%,VS = 500V (Note 2) AC,1 minute Isolation voltage BVS AC,1 second,in oil DC,1 minute,in oil (Note 2) Min. ? 1x10
12
Typ. 0.8 10 ? 10000 10000
14
Max. ? ? ? ?
Unit pF O Vrms Vdc
5000 ? ?
?
3
2003-10-21
TLP716
Switching Characteristics (Unless otherwise specified, Ta= Ta=-40 to 100C,VCC=4.5~5.5V)
CHARACTERISTIC propagation Delay Time to Logic High output
propagation Delay Time to Logic Low output propagation Delay Time to Logic High output propagation Delay Time to Logic Low output Switching Time Dispersion between ON and OFF Output Rise Time Output Fall Time Common Mode transient Immunity at High Level Output Common Mode transient Immunity at Low Level Output *All typical values are at Ta=25C Note 4 : Capacity of a probe and a wire. CML CMH 3 VCM=1000Vp-p,IF=12mA, Vo(Max)=0.4V,Ta=25C 10000
SYMB OL tpLH
TEST -CIRCUI T
CONDITION IF=0? 12m A
IF=12*0mA VIN=5*0V (IF=8*0mA)
MIN. -- -- -- -- -- -- --
TYP. -- -- -- -- --
MAX.
UNIT
RIN=100O
CL=15pF (Note 4) RIN=430 CIN=33pF CL=15pF (Note 4)
75
ns
1
tpHL
75
ns
tpLH 2 tpHL |tpHLtpLH| ' " " 1
65
ns
VIN=0*5V (IF=0*8mA)
65
ns
RIN=100, CL=15pF (Note 4) IF=0*12mA IF=12*0mA RIN=100 CL=15pF (Note 4)
45
ns ns ns
-- -- -- --
VCM=1000Vp-p,IF=0mA, Vo(Min)=4V,Ta=25C
-10000
V/us
--
--
V/us
TEST CIRCUIT 1 : tpLH , tpHL
IF=12mA(P.G)
(f=5MHz , duty=50%)
VCC
INPUT MONITORING NODE
0.1uF
VO
MONITORING NODE
50%
IF
VOH
VCC VO
GND SHIELD CL=15pF
CL=15pF
RIN=100
1.5V
VOL
tpHL
TEST CIRCUIT 2 : tpLH , tpHL
VIN=5V(P.G)
INPUT MONITORING NODE (f=5MHz , duty=50%)
tpLH
VCC CL=15pF 0.1uF
Vo MONITORING NODE
VIN
VCC
50%
VO
GND SHIELD CIN=33pF RIN=470
CL=15pF
VOH
1.5V
VOL
tpHL
The PROBE and JIG capacitances are included in CL. (P.G) : Pulse Generatior
tpLH
4
2003-10-21
TLP716
TEST CIRCUIT 3 : CMH , CML 1000V 90% SW A V B 90%
IF
P
6
VCC
VCM 0.1uF VO VCC 10%
tr
tf
10%
2 3
5
GND SHIELD
F
4
*E B ` :IF=0mA SW Vo 4V 0.4V
CMH
*{ VCM
*|
*E A ` : IF=12mA SW
CML
CMH**
800(V)
tr(s)
CML=-
800(V)
tf(s)
CML (CMH) is the maximum rate of rise (fall) of the common mode voltage that can be sustained with the output voltage in the low (high) state.
RESTRICTIONS ON PRODUCT USE
*
020704EBC
TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc.. The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer's own risk. Gallium (GaAs) Arsenide is a substance used in the products described in this document. GaAs dust or vapor is harmful to the human body. Do not break, cut, crushu or dissolve chemically. The products described in this document are subject to the foreign exchange and foreign trade laws. The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. The information contained herein is subject to change without notice.
*
* * *
*
5
2003-10-21

▲Up To Search▲

Price & Availability of TLP716

	To Download TLP716 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .